Wacker Neuson PSG2 500

PSG2 500

Pumps for low water level pumping

These high performance single-phase submersible pumps are ideal for job sites needing fast, dependable, low level water pumping. Pump can start in less than 1/4-inch of water when it is primed through the discharge port. No matter how large or small the job. Wacker Neuson submersible pumps offer the versatility and durability contractors need for light dewatering. Suitable for most 110V outlets, these pumps offer big pump features for small pump investment.

• Pumps feature a top discharge for efficient motor cooling and continuous operation, even when pumping at low water levels.
• Miniature thermal motor protector prevents overheating and dry run conditions.
• Multi-directional discharge coupling for vertical and horizontal hose run without kinking.
• PSG2 500 is ideally suited for low pump applications with minimal solids present. It can pump a reasonable flow sitting on the surface.
• PSR1 500 is ideal for dewatering of flat concrete, like basement and factory floors. For use where a sump pump cannot be installed and water must be almost completely removed.

Specifications

		PSG2 500
Dimensions
L x W x H  in		8.27 x 8.27 x 11.22
L x W x H Shipping in		14.96 x 9.72 x 9.72
Diameter Discharge in		2
Operating weight  lb		23
Shipping weight  lb		29
Cable length  ft		39.5
Cable Size  AWG		16
Operating height Min. Running Water Level in		0.2
Operating data
Total head  ft		39.5
Discharge capacity  US gpm		62.4
Solids diameter  in		0.236
Engine / Motor type		60 Hz Single ~
Impeller Type		Semi-Vortex Urethane Rubber
Operating voltage  V		110
Current Full Load with 110V A		6.1
Current Start with 110V A		12.5
at rpm  rpm		3,255